Actaris meter software3/12/2024 The EMU meter transmits current data to the device’s M-Bus interface every 40 seconds, so that the readout data is approx. The transmission of data from the EMU meter to the M-Bus protocol computer only works if the EMU meter is connected to at least two phases of the mains voltage network. The current consumption of the M-Bus interface is then equivalent to one standard load. The meter can optionally be supplied with 230 V. If an M-Bus master interface is used that is designed, for example, for up to 120 standard loads, a maximum of 40 EMU M-Bus meters can be connected. In the normal version, the current consumption of the M-Bus interface is equivalent to 3 standard loads. Please refer to the meter documentation for further information regarding this. The meter transmits this data in the standard EMU parameterization, or if the parameter set is set in the device to 00000 hexadecimal. Only the standard meter data will be read. This function block is used to read electricity meters from EMU:
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |